Stromquist & Company’s, Bob Koch, shows you the power of using the Honeywell RM7800 Burner boiler Controller with the S7800 trouble shooting display. Using the RM7800 Fault codes in the display makes troubleshooting your burner system a breeze.
If you are in Georgia or Florida you can contact one of the control pros at Stromquist & Company for more information on the Honeywell RM7800 flamesafe guard controller. If you are in another part of the country one of our fellow members of Controls Group North America can hook you up.
9 Responses
Bob is awesome
What can cause a code 111. I’ve changed out the boiler relay and it is still locking the boiler out. It’s not doing it everyday. It will run for a couple of days then trip. I’ve check everything out start it up and it will run good for a day or two.
Pilot flames failed,lockout 28
I am using a RM7890a 1015 control, with a R7847a 1033 AMPLIFYER
I keep getting a fault code 46. Both controls are new.???
The lead boiler is running fine with the same exact control.
But when I put new control on same boiler I get fault code 46
Bob, s7800 says #39 what could be problem on RM7800L
What is a fault code 18 indicate on a 7800 controller?