Check out the new Johnson Controls Bacnet/IP to MS/TP Router

Johnson Controls, Inc. announces the release of the TL-BRTRP-0 router, which is a small, economical, portable BACnet/IP to MS/TP router.

This new portable router is intended to be used as a hard-wired connection interface between a BACnet/IP-based software tool and BACnet MS/TP-based controllers. You use the TL-BRTRP-0 router as a connection interface between:

Facility Explorer FX07, FX14, and FX16 BACnet Field Controllers and FX CommPro BACnet software (directly replaces the LP-KIT204-000C)

Facility Explorer Programmable Controllers (FX-PCs) and the Facility Explorer Programming & Commissioning Tool (FX-PCT)

Metasys® Field Equipment Controllers (FECs, VMAs, and IOMs) and the Controller Configuration Tool (CCT)
CCT must be at Release 5.3 or later to support the BACnet routing connection.
The TL-BRTRP-0 Portable BACnet Router does not require batteries or a transformer for power. Instead, it is powered via a USB connection to your computer. A USB cable is provided.
The TL-BRTRP-0 router features the following two methods for making the field connections to the BACnet MS/TP trunk wiring:

screw terminals

RJ-11 connector: the pinout of this RJ-11 connector connects to the multi-headed cabled included with the LP-KIT200-000C RS-232 to RS-485 N2 converter.
FX-PCs and MS-FECs support a BACnet router connection only at the field controller (FC) bus, not at the sensor actuator (SA) bus.

Please note this product is only sold though authorized Johnson Controls Systems Integrators. If you are in Georgia contact one of te control pros at Stromquist & Company for help locating a local Johnson Controls Systems Integrator.


2 Responses

Leave a Reply

Your email address will not be published. Required fields are marked *

Stay In The Know. Join The Control Trends Newsletter.

What Type of Content Would You Like to Receive?
This field is for validation purposes and should be left unchanged.