Tim’s Tech Tip: Setting Up a Kreuter “Stop Sign” VAV Controller

In this extensive training video, Stromquist & Company’s, Tim Chamblee teaches you step-by-step how to control a VAV box with the Kreuter pneumatic VAV controller. There are hundreds of thousands of the KMC CSC3011 series of pneumatic VAV controllers. Thanks to Tim, we know how to set them up, calibrate, and troubleshoot these pneumatic VAV controllers.


11 Responses

  1. I would like to know if you have a video on how to adjust kmc controllers in a double duct system.

  2. Superb blog you have here but I was wondering if you knew of any message boards
    that cover the same topics talked about here? I’d really like to be a
    part of online community where I can get opinions
    from other knowledgeable individuals that share the same interest.
    If you have any recommendations, please let me know.

  3. I work in a older prison with KMC controls that work off of large chillers and a steam heat system that runs through older air handlers. We have lost most of our experience as far as HVAC techs go. I am working to try and see if I can get system back working properly, is there video or study material on such a system. Works off air pressure???

  4. Hi Marshall,

    Thanks for checking us out. We have lots of videos, but it sounds like you might need a full blown pneumatics training class to get up to speed. Is that accurate? If you can let me know what part of the country you are located in, I can see what I can find resiurse wise near you. Good things, Eric

  5. Pingback: Umzugsfirma Bern
  6. Pingback: Hypnose

Leave a Reply

Your email address will not be published. Required fields are marked *

Stay In The Know. Join The Control Trends Newsletter.